Set glue to appropriate temperature to ensure proper pattern control and clean cutoff at glue nozzle.

 

---

 

Standard Settings (for HB Fuller Advantra adhesive)

 

* Glue nozzle pressure for adjustable regulators is dependent on glue nozzle model installed on machine. If unsure of correct setting for your machine, refer to Nordson documentation or pneumatic page in electrical drawings.

 

---

 

SAMPLE IMAGE

 

Adjust Glue Tank Temperature:

To globally set all glue components to same temperature, do the following:

 

1)Press and hold tank key for three seconds; left display will flash

2)Use arrow key to scroll left display to 0

3)Press enter key

4)Right display flashes

5)Use keypad to enter temperature recommended by glue manufacturer; Aagard recommended glue temperature is 335°F - 350°F

6)Press tank key again (see first step); all components will begin to heat/cool to new temperature

 

Set Auto-Standby:

Configure auto-standby by setting parameters on the Nordson control panel. You can automatically go into standby mode a number of different ways. Typically, however, it is done after a certain amount of inactivity (0 to 1440 minutes, or 0-24 hours). You may also set the amount that the temperature will drop (default is 100°F). Additionally, you may take the tank out of standby manually using a function key, or automatically after a set amount of time. Information on how to configure these settings may be found in the Nordson Manual (Section 3, Setting Up the Melter).

 

Adjust Glue Tank Pressure:

Follow these instructions to set glue tank air pressure:

 

1)Gauge indicates the air pressure supplied to tank pump

2)Use Allen head adjusting screw located to right of gauge to adjust air pressure