Every Shift, or Daily

Check conveyor belts for wear, alignment and cleanliness

Check gearboxes for leaks

Check photo eyes and reflectors for proper operation and positioning

Check vacuum lines, hoses and cups

Clean dust and debris from photo eyes

Clean glue from machine

Drain air filters and regulators

Inspect machine for unusual component wear or fatigue

Remove debris, dirt, grime, dust and other foreign materials from moving parts to lengthen life

Every 50 Hours of Operation

Check chain drive for tension and adjust to ½ to ¾ inch total play between sprockets, if needed

Grease rod ends, using #1 or #2 food grade grease

Grease Thomson bearings on magazine, using #1 or #2 food grade grease compatible with Mystic FG 2

Lightly oil roller chain if it runs continuously

Every 100 Hours of Operation

Check vacuum pump oil level and fill as needed. Refer to Manufacturer’s data sheet for recommended oil and maintenance information

Weekly

Check air cylinders, replace as needed

Check and clean or replace vacuum filters

Check chain and belt tension

Check chains for wear and proper alignment

Check for loose fasteners

Lightly oil v-wheel rollers and rails

Monthly

Check all safety circuits (Guard Doors, E-Stop Buttons)

Check cartridge bearings, replace as needed

Check for bent shafts, screws or other components

Check V-rollers periodically; tighten if required How To

Check chain adjustment; lightly oil roller chains

Every Six Months

Check gear box fluid levels and refill as necessary. Refer to Manufacturer’s data sheet for recommended oil, grease and maintenance information

Grease Elmo Rietschle Vacuum Pump, applying 1 full pump of grease. (or alternatively, 2 grease pumps once per year) Important! Do not over-grease or grease can get into motor windings and cause motor damage!