CAUTION
Before operating equipment, see Safety Recommendations
Read and observe all safety precautions in this manual,
and in vendor literature, before proceeding
|
Prior to starting your packaging system
•CHECK TO MAKE SURE ALL PERSONNEL, TOOLS AND EQUIPMENT ARE CLEAR OF THE MACHINE
•Turn on hot melt system; allow the system time to reach normal operating temperatures
•Install and close all guard doors
•Load the magazine(s) with blanks
•Check to make sure product is available
•Once again, CHECK TO MAKE SURE ALL PERSONNEL, TOOLS AND EQUIPMENT ARE CLEAR OF THE MACHINE
Shutdown Warning
Failure to properly shut down the PC may void the warranty!
Switch on
|
The Industrial PC does not have its own main switch. The Industrial PC will start when the equipment is switched on, or when it is connected to the power supply.
|
Shutting down
and
switching off
|
When the plant is switched off, or when it is disconnected from its power supply, the Industrial PC will be switched off.
Control software such as is typically used on Industrial PCs permits various users to be given different rights. A user who may not close software may also not switch the Industrial PC off, since data can be lost from the hard disk by switching off while software is running
|
Warning!
|
First shut down, then switch off the PC!
If the Industrial PC is switched off as the software is writing a file to the hard disk, the file will be destroyed. Control software typically writes something to the hard disk every few seconds, so the probability of causing damage by switching off the PC while the software is running is very high!
|
Warning!
|
When you have shut down the Industrial PC, you have to switch off power supply for at least 10 seconds before rebooting the system. After resetting power supply, the PC will start booting automatically.
|
To properly shut down the PC, contact a Level 2 or higher Operator.
|