|
|
Pressure Sensor Replacement and Setup |
|
|
|
|
|
|
|
Pressure Sensor Replacement and Setup |
|
|
|
|
|
Pressure Sensor Replacement and Setup
|
|
|
Pressure Sensor Replacement and Setup |
|
|
|
|
|
|
|
Pressure Sensor Replacement and Setup |
|
|
|
|
|
Replacement
Tools Required:
| • | Adjustable Wrench |
Routine:
| 1) | Turn off main air |
| 2) | Disconnect the electrical wire on the sensor |
| 3) | Loosen the sensor using the crescent wrench |
| 4) | Remove the sensor and replace with the new one (be sure to use thread tape) |
| 5) | Tighten the sensor down so it’s easily readable |
| 6) | Reconnect the electrical wire on the sensor |
| 7) | Turn on main air |
ISE40A Pressure Switch Setup (A model only):
| 1) | Enter Function Selection mode – Press and hold the S key (> 2 sec.) until the display reads F 0 |
| 2) | From F 0 press the UP button to navigate to F 1 and press the S key 3 times until the display reads P_1 |
| 3) | Using the UP and DOWN buttons set display to the setting on the Aagard wiring diagram (Aagard standard setting is 65 psi) |
| 4) | Press the S key once to display H_1 |
| a) | Using the UP and DOWN buttons set display to 1.0 |
| b) | Press the S key 2 times to return to F 1. |
| 5) | Return to the main display by pressing and holding the S key for > 2 seconds; the main display should be showing a low number reading |
NOTE: The Out 1 indicator should not be illuminated at this point if system air has not yet been applied
System pressure switch settings – P_1 = 65.0
By setting the ISE40A switch up in this manner, the pressure switch will provide an output when system pressure gets to 65.0 PSI; it will loose its signal when it drops below 64.0 PSI.
